Maintenance method of angular contact ball bearing

2017-11-16  From: luoyangyitezhouchengyouxiangongsi Browsing times:361

1. when the bearings run to a certain period of time (or maintenance period), the bearings are all removed;

2. with cleaning diesel or kerosene soak cleaning bearing, if the technical condition is best to open the sealing cover cleaning;

3. after cleaning the air dry cleaning oil, appearance inspection whether damage;

4. use a 150mm or so, the diameter of angular contact ball bearing diameter equal to the best (hollow tube), one end of a bearing;

5. hand fast rotating bearings at the same time, the stick (woodwind) at the other end of the top in the ears or listen to the audio amplifier microphone defence bearing rotation noise;

6. fixed bearing horizontal toggle stick, check whether the bearing wear loose phenomenon;

7. The FAG bearings with serious loosening, excessive rotating noise and serious defects should be eliminated and replaced by the same type;

8. take a bucket of the right amount of grease (high quality yellow dry oil) with a slow fire melting (not overheating), the detected bearings into the barrel, soaked to no bubble overflow. Take out the bearing before the grease is cooled, and the residual grease is less. After the grease is cooled, the angle contact ball bearing is removed, and the residual grease is more. Determine the amount of grease residue as required.

9. with soft cloth or toilet paper to wipe the grease outside the bearing, the FAG bearing original assembly to the pulley, maintenance work is finished.

Contacter:Fang sir

Phone:15837931458

Address:Luoyang city.Henan province Mangshan Town shijiatun industrial zone

Company Email:lyytc@126.com

Website:yitezhoucheng.boss258.com


Keywords: 轴承   bearings        

Copyright © 2007-2008 YTZ Corporation. All Rights Reserved.

Powered By Lyland.cn  Count:


CopyRight © All Rights Reserved: luoyangyitezhouchengyouxiangongsi Technical Support:YUOyanglandiankeji Site Map XML


Follow us